performance of industrial grinding dust collector is mainly used for single or several points of dust removal, and the dust point is not often fixed in the place (such as welding). The dimensions can be customized according to different needs, and customers can use the equipment without too much installation. Multi-point dust removal due to site restrictions, while the use of stand-alone dust removal equipment. Single-machine dust removal equipment is widely used in the casting industry, ceramic industry, glass industry and not afraid of fire materials, cement building materials, grinding wheel manufacturing, chemical products, machining and other industries of dust removal, the product is compared with significant metal chips, casting sand, such as lathes, grinding machines, milling machines, grinding machines, polishing machines, and medium gravity dust, Such as cement, ceramic powder, gypsum powder, asbestos powder, charcoal powder, pigment, bakelite powder, plastic powder and so on. And the non-fiber dust with light gravity have good dust removal effect, and the dust removal rate of the unit is greater than 90%.

The single-machine dust collector belongs to the mechanical jitter dust collector. Its basic structure consists of three parts: fan, filter and dust collector. Each part is installed in a vertical frame. Fan adopts centrifugal fan, large air volume, high wind pressure, and adopts noise reduction measures, low noise. The filter adopts flat cloth bag group, each cloth bag is equipped with spring steel wire mesh, the filtering effect is good. The flyaway mechanism uses the motor to drive the eccentric wheel and the connecting rod to make the cloth bag shake and stick to the dust on the surface of the filter bag. The dust collector is equipped with an access door for easy maintenance and bag changing.

performance of industrial grinding dust collector design technology Yes, the use of the current general dust removal technology for dust removal, dust removal rate easily meet the environmental standards, the use of chamber pulse injection technology for dust removal, dust removal rate prohibited by environmental inspection, It is a more common dust removal equipment used in industrial dust removal at present, and its figure can be seen in various dust removal conditions, which is favored and praised by customers.

The newly installed pulse bag dust collector has a running-in period, after the running-in period, the equipment can achieve a good dust removal effect, so the operation and commissioning during the running-in period is important, the debugging and operation of the pulse bag dust collector in the running-in period:

1. During the beginning of the operation of the accessories, abnormal temperature, pressure and moisture problems often occur, which will cause damage to the new pulse bag dust collector device.

2, the installation of dust filter bag, whether there is a drop bag, loose mouth, wear and other situations after use.

3, after the operation can be visually measured chimney emissions to determine. Pay attention to whether there is condensation in the bag room and whether the ash removal system is. Prevent clogging and erosion, ash accumulation will affect the production of pulse bag dust collector. The adjustment of cleaning cycle and cleaning time is an important factor for the performance and operation of the pulse bag dust collector.

4. Whether the air volume and the pressure and temperature of each test point are consistent with the design. Fan rotation direction speed bearing vibration and temperature. Whether the pulse bag filter operates normally directly affects whether it can be put into use on the assembly line, otherwise, the pulse bag filter is likely to lose its effectiveness soon.

5, debugging pulse bag dust collector running-in period to be careful and careful. The sharp change in the gas temperature of the dust removal accessories will cause the deformation of the fan shaft, resulting in an unbalanced state, and the operation will vibrate. Once the operation is stopped, the temperature will drop and vibration will occur when it is restarted. If the cleaning time of pulse bag dust collector is too long, it will cause leakage and damage of filter bag.

There are two main reasons why the lift valve lacks a jump stop due to compressed air:

1. After long-term operation of the lifting valve, the seals wear out, forming compressed air leakage, resulting in a lack of gas supply.

2. The oil-water separator between the air storage tank and the lifting valve is blocked by the compressed air.

performance of industrial grinding dust collector https://www.kaisenfilter.com/KSZHDM-01-Combined-Grinding-Dust-Collector.html